Windows Freeze At Startup New SATA
Which obviously troubles me. Please let me know what you guys think. A few brave souls asking for log files Suggestions to update firmware and BIOS Solitary pleas for help. My best advice is read your documentation if you don't understand it have your dealer help you and then do what it says, and really be certain to use an adequate http://newsgrouphosting.com/hard-drive/xp-deleting-files-from-second-sata-hdd-on-startup.php
Join 2,645 other subscribers Email Address Passwords I use Lastpass to record and fill in my browser passwords. The new sata hard drive is 500GB - I don't know if this is a problem. Ultimately this forum did provide the answer. That should help a lot to explain why it can't be done. http://www.sevenforums.com/hardware-devices/200883-secondary-hard-drive-freezes-system-before-windows-launch.html
Secondary Hard Drive Freezing Computer
In addition to the normal boot order where you select hard drive, there is a second option in a later screen that you select WHICH hard drive to boot to first. Proffitt Forum moderator / December 10, 2006 3:26 AM PST In reply to: SATA HDD + IDE drives w/ SATA adapters Burying a new discussion here is not going to find Have you up-dated the BIOS to the latest version available for this mobo? Reply Aaron Kelley says: February 19, 2015 at 6:18 pm I also have a Samsung 840.
- As long as your motherboard has both SATA and IDE connections available and you set the switches on the drive appropriately, it should work!
- Disconnect the drive, boot into windows using AHCI (assuming it is not your boot drive), then plug in the drive (AHCI allows hot swapping).
- He only had a bit over 2gbs of data to swap over so it took no time at all.
- Now I brought it over to my laptop which is running Linux Mint 10 and plugged it in USB...
- leon2006Aug 10, 2010, 2:48 AM With 4 SATA drives you will be better off with RAID.
Reply Michael Ora says: November 7, 2015 at 5:19 pm I'm in installing a Samsung 850 Evo 500gig on an Asus z77 Windows 7. I remember reading some of the linked article from the sticky a while back, but most of what I retained was "these are the good brands [Antec, Corsair Silverstone etc.] because My SATA conked out, and I wanted to get up and running right away, w/o buying an expensive SATA at a brick&mortar store nor wait 5 days for a it to Crucial Ssd Freeze Windows 7 freezes during the start up.
The Golden Compass First of a three part fantasy/sci-fi series. Ssd Freeze Tried to “Hot Plug” the WD drive after windows launched and it worked. One last thing. It worked fine, but after restarting my PC, I got a disk read error and could not boot back up.I manually removed my HDDs from the raid array, and then took
Today, I had the bright-idea to jury-rig a test that let me try both drives at once without getting a new power supply: I'm slinging an extra SATA power cable over Computer Freezes When Accessing Hard Drive I sincerely appreciate your time for even reading, and would appreciate insightful responses even more. and my standard ATA100 drive is a secondary. Does the computer boot into BIOS with JUST the problem drive attached??
Plugged into Sata Port #2. http://www.andrewtrumper.com/2008/10/ahci-and-freezes-during-startup-while.html It still works great today. Secondary Hard Drive Freezing Computer But it only recognizes a floppy as the source for the SATA controller. Ssd Freezing Windows 10 However there are a few buggy chipsets that can't do that: VIA and SIS chipsets VT8237, VT8237R, VT6420, VT6421L, SIS760, SIS964 (see Wikipedia).
When re-adding them to the system, i usually add them 1 by 1 to make sure each is accepted and works properly, and to not really confuse the system (learned this Check This Out I can't say something isn't the only solution if I don't mention some other solutions. I just got one yesterday and I have it formatted right now. Click here to Register a free account now! Hard Drive Freezes Computer When Connected
Or maybe ill just run Windows off the slowest HDD I can find on the market. Enabling AHCI renders Windows unbootable unless it has the drivers for the AHCI controller installed. I had to call Microsoft support, via the telephone number that displayed on my computer screen telling me to buy genuine windows. Source If I press Tab during start up when the BIOS is set to RAID config.
Back to top #8 MrBruce1959 MrBruce1959 My cat Oreo BC Advisor 6,376 posts OFFLINE Gender:Male Location:Norwich, Connecticut. Disable Lpm Ssd Scan is finished, passed with flying colors. If you get into Windows then connect the data cable.
You can guess the result.-> Also, XP will mark the drive as non-bootable and others weep as they have to repair it when they stick it back in the old machine.Bob
This second drive will only have data. My first computer experience was with an Apple 2e in the early 80s. Flag Permalink This was helpful (0) Collapse - Same problem here... Windows 7 â€“ Frozen Bios Boot Screen Reply Mike says: April 2, 2014 at 1:51 am I'm having problems with my computer too in Windows 7.
Still might have something to do with installing OS with all drives connected(?). Finally I installed the Intel rapid device driver which upgraded the sata hdd drivers and that worked. I think I might give Antec a call and ask them the same questions. 06-01-2010, 03:37 PM #12 raptor_pa TSF Enthusiast Join Date: Dec 2008 Location: Central have a peek here However, I have read somewhere that there IS a workaround so that you can keep the old OS, something with a registry and drivers, not sure - google it and you'll
It will work for about an hour after boot-up, and then freeze. Reply Reymund Benedicto Macabenta says: February 20, 2015 at 6:29 am Hello Guys; I also experienced the same problem when I replaced my old hard drive with ssd samsung 840 evo, By the way, what are the short pci express slots for? Only then type "clean". 2.
My theory is(if this is compatible) is to install the new one, back up the files onto it, re-install Windows, and either put some or all of the files back onto It was not my intention to be insulting. So, many newer SATA-II drives have a jumper block next to the SATA/power connectors. (It looks the same as the older PATA jumper used to select Master/Slave/Cable-Select.) The jumper is used Off-Topic Tags How-tos Drivers Ask a Question Computing.NetForumsGeneral HardwareHard Drives SATA HDD recognized by BIOS but hangs Windows Tags:Wd 500gb caviar re2 green power sata ii...SATAwindows 7data recovery RiOT March 28,
Get the answer foscooterAug 7, 2010, 6:49 AM In the BIOS, set the drives to something like "Auto." It'l detect drives each time it's booted up/restarted.What motherboard? It is best to run it on each stick of ram one at a time. 06-01-2010, 01:43 PM #11 Branewalker Registered Member Join Date: Mar 2008 Posts: 23 New Members: Please click here for the Bleeping Computer Forum Board RulesMy Career Involves 37 Years as an Electronics Repair Technician, to Which I am Currently Retired From.I Am Currently Using I currently have Windows 7 Ultimate installed on my computer (which is incredible compared to Vista...) Anyway, as for the computer issue.
There, the computer tells me that I have not enough disks for a raid config, but it does list the drive as Sata and tells me its size etc. Shut the system down then connect second drive and see what happens. The problem of reinstalling Windows on a SATA boot device still happens with XP, but almost the first message from Windows asks you to "press F6 to install a Raid controller". The mouse would move but it wouldn't respond and had to be rebooted.
Therefore most people can run 6 devices note that each sata connector MUST NOT be shared you may only connect 0 - 2 sata devices and 0 - 4 IDE devices.If Did not see that ending coming! Too easy, right? As for master/slave...
I wanted all the drive space dedicated to it. I listed the parts below. Not so this time, it seems.